Shadow-opacity = 0.5 Set if you want different colour shadows shadow-red = 0.0 shadow-green = 0.0 shadow-blue = 0.0 The shadow exclude options are helpful if you have shadows enabled. Shadow-offset-y = -5 The translucency for shadows. Shadow-offset-x = -5 The top offset for shadows. Shadow-radius = 5 The left offset for shadows. Fix some weirdness with ARGB windows.Ĭlear-shadow = true The blur radius for shadows. No-dock-shadow = false Zero the part of the shadow’s mask behind the window. No-dnd-shadow = true Avoid drawing shadows on dock/panel windows. Shadow = true Don’t draw shadows on DND windows. # Enabled client-side shadows on windows. buffer-age means auto-detect using GLX_EXT_buffer_age, supported by some drivers. Usually, double buffer means 2, triple buffer means 3. copy is fastest, but may fail on some drivers, 2-6 are gradually slower but safer (6 is still faster than 0). undefined is the slowest and the safest, and the default value. Could be undefined (0), copy (1), exchange (2), 3-6, or buffer-age (-1). glx-no-rebind-pixmap = true GLX backend: GLX buffer swap method we assume. Probably could improve performance on rapid window content changes, but is known to break things on some drivers (LLVMpipe). glx-use-copysubbuffermesa = true GLX backend: Avoid rebinding pixmap on window damage. May break VSync and is not available on some drivers. My tests on nouveau shows a 200% performance boost when only 1/4 of the screen is updated. Glx-copy-from-front = false GLX backend: Use MESA_copy_sub_buffer to do partial screen update. My tests on nouveau show terrible slowdown. My tests with nvidia-drivers show a 10% decrease in performance when the whole screen is modified, but a 20% increase when only 1/4 is. Glx-no-stencil = true GLX backend: Copy unmodified regions from front buffer instead of redrawing them all. GLX backend is typically much faster but depends on a sane driver. For you to use this configuration, copy and paste it into a pluma file and save in “/home/username/.config” as “nf” I use the following configuration (see below) in a Compton conf file. Go to Mate Tweak and set it to Marco with no compositing. It should work well on yours, but I can make no guarantees) (Note, the following method works well on my system. I use VMs quite a bit, so I have got round this problem by the following method:
0 Comments
Leave a Reply. |